How to install the LCD advertising machine inside the elevator?
DATE:Sep13,2022FUENTE: VETO
1. You can directly punch holes in the car wall, then go outside the box, and finally lead the power cord of the elevator LCD advertising machine to the power box on the top of the car, pay attention to fix the power cord to avoid scratches when running the elevator.
Fix the installation backboard to the wall with an expansion screw, and hang the installation hook of the LCD advertising machine into the corresponding hook hole on the installation backboard when the lock is open. To ensure the level of the advertising machine, install the backboard. The level should be sought.
2. If you are worried about leaving unsightly holes on the elevator car wall after removing the equipment, it is recommended to punch a hole on the top of the car and lay a small section of open wire to the equipment. Even if the elevator advertising machine is removed, it will not be in the car. Leave an ugly power cord hole on the wall, and finally lead the power cord of the elevator Focus LCD advertising machine to the power box on the top of the car, pay attention to fix the power cord, but it is best to add a multi-function socket, so as not to affect the use of this by the elevator personnel. power supply.
When the wall is kept clean, first stick the double-sided tape to the backboard, then stick the backboard to the wall, and then apply glass glue to the center square and four sides to fix it. When fixing, ensure that the backboard of the elevator advertising machine is installed horizontally. Finally, connect the power cord of the elevator advertising machine, etc. After the glass glue is completely cured, the power cord is introduced from the opening of the back panel after the back panel is fixed, or from the openings on the four sides above the back panel.
